KTM 250 SX-F

Akrapovic Evolution System (2021-2022 KTM 250 SX-F)

When you purchase a 2021 KTM 250 SX-F TLD version the bike comes with a slip on Akrapovic Evolution muffler. However, I know that sometimes, certain machines react better to full systems rather than slip ons, we decided to get the full Evolution system to see how it changes the KTM 250 SX-F’s engine character. 

The Akrapovic Evolution full muffler system has a similar character to the slip on version that comes with the Factory Edition, but with added bottom end roll on and mid range. If you’re expecting a ton of added RPM response (excitement) from your full system compared to your standard slip on, you will be disappointed. You simply will not be getting that much added rpm response with the Akrapovic full system. Instead of a smooth roll on that the TLD version comes with, it now has a little more pulling power in second and third gears and pulls those gears much longer.

IMG_3757.jpg

Mid range pulling power is increased, but the muffler pitch is so quiet that you never really feel like you’re “on the gas”. The mid range pull is much more linear and longer than the standard slip on or stock muffler and being able to shift a little earlier with the full system makes it easier to ride in softer conditions. I had a hard time with the KTM 250 SX-F at softer tracks not recovering, if I shifted early out of a corner. With the full system at the same track I was able to shift into third and not have to worry about covering the clutch as much. The full system just simply gives me more “meat” in the mid range.
 Top end and over-rev is where this Akrapovic Evolution system shines. Adding top end and over-rev to the already very capable KTM 250 SX-F only makes this machine more fun to ride. Again, I can’t stress on how deceiving this system is because of it’s quiet nature. I really had to focus in and feel how quick I was going from point A to point B on the track because the pitch of the muffler never sounds “racey”. However even with its quiet note, the Akrapovic full system lets the KTM pull so much farther that it almost feels like I swapped to an aftermarket ECU. The connection to the rear wheel with the full system is unmatched and even though it may seem like it’s not very responsive, the KTM with the Akrapovic full system allows the rider to get on the gas sooner through corners. 

As described the Akrapovic badging will eventually get marked off when cleaned.

As described the Akrapovic badging will eventually get marked off when cleaned.

If you’re reading this and wondering why you can’t simply purchase an Akrapovic headpipe for your Akrapovic slip on, the answer is they will not mate up. The Akrapovic slip on has a smaller diameter OD, (where it meets the stock headpipe), so purchasing just the headpipe will not work. 

A couple of durability notes: 

-The Akrapovic lettering on the headpiece resonance chamber will wear off after a few washes. 

-The Akrapovic muffler stickers will burn away around the 7 hour mark. 

-The overall quality of the system and the parts inside the muffler are second to none. The muffler packing lasts longer than other aftermarket systems and the hardware it comes with is superb. 

-Is the system worth the $1200.00 price tag? Comparing it to other systems out there, I would say you’re getting what you’re paying for. A lighter, race oriented system that gives the rider better overall power throughout the rpm range. 

FMF 4.1 Muffler System (2021 KTM 250 SX-F)

My son and I have been going back and forth on mufflers for his KTM 250 SX-F and have went though about three until we settled on the FMF 4.1. We have tried the HGS (which was good), a Yoshimura, as well as a Pro Circuit system, but for his riding style and what he was looking for from the engine character, we decided on the FMF 4.1 system. Why? Here are some reasons why the FMF 4.1 system works well for Aden and the KTM 250 SX-F. 

IMG_2904.jpg

First off, the FMF 4.1 system looks beautiful and is easy as pie to put on. Installation literally took 10 minutes and I like that FMF pipe springs last longer than the stock KTM pieces. Aden rides lower in the rpm and only revs his bike in the air (which he thinks helps him but it really doesn’t) so he needs some low end rpm response as well as some low end torque to help get the KTM back into the meat of the power (or “recovery”). You will get more low to mid RPM response as well as more mid range pulling power with the 4.1. Top end is increased slightly plus the over-rev is as good as stock. It is one of the few times that I was impressed with a muffler because it was actually better than stock in almost all areas. THIS IS VERY RARE! Coming out of corners the KTM 250 SX-F now has some more excitement in second gear and pulls harder than the stock system. Third gear roll on is also noticeably more reactive to your throttle hand (increased connection) and can allow for a lazier rider to have more pull in softer loam. We did pull the spark arrestor/insert out with good results and decided to leave it out for maximum throttle response and torque feel. Leaving it in will kill a little low to mid response, yet you still will get better torque feel over stock. 

IMG_2903.jpg

The downside is that you must keep up on your muffler packing (every 10-12 engine hours) because the FMF will blow out and that could damage your expensive titanium can. Just in case you’re numbers guy, did I mention that you will lose almost two pounds with the titanium 4.1 system? If you slap on spring forks on your KTM, you will be gaining almost three pounds. You can get most of that weight gain with the spring fork back down with a 4.1 Titanium FMF Muffler system.

IMG_2905.jpg

Things to look out for? I can burn a lot of pants on the headpipe of the FMF system. The magabomb portion of the headpipe can burn your pant just above the boot when sticking your leg out in deep ruts. This has happened on only a couple different brands of gear (FXR, FLY) with the FMF headpipe installed. Overall we are happy with this system for the way Aden likes to ride and will be refurbishing his mufflers every 10-12 hours in order to keep the most performance possible. Hopefully FMF will have these back in stock in the near future so be on the lookout over on their website that gets updated weekly on what is in stock. Damn you Covid!

HGS Exhaust System For 2021 KTM 250 SX-F

Something that most riders (including me) may not see a lot of in the states is HGS exhaust systems. HGS is a Netherlands based company that has been making exhausts since the early 90s and are mostly popular among European club riders and of course many factory supported MXGP teams. I had the chance to try out an HGS exhaust with the Conical silencer on a 2021 KTM 250 SX-F supplied by Bud Racing (American porter for HGS) and wanted to get you all some feedback on a muffler system you may have never heard of.

IMG_1668.jpg

The stock engine character of the 2021 KTM 250 SX-F has a smooth roll on power delivery that comes on strong through the mid to top end range. The over-rev of the KTM 250 SX-F is down right impressive and allows the rider to stretch each gear farther than any other 250 MX machine out there. Other mufflers I have tested provided great mid-top end gains but it was very difficult to get more low end. I was looking to get some more low-mid range gains from the HGS and that is exactly what I got. First things first though, how was the HGS to put on? I am not going to lie, it wasn’t the easiest system to bolt on! The headpipe fitment to the cylinder head was very tight and took some coaxing to slide into the exhaust flange. Once I finally got that slipped over and fit up the rest of the system bolted on without issue. I am not going to look forward to taking this system off as I know that headpipe will be a tough one to get out even with the generous amounts of anti-seize I put on around the lip of the HP. 

The weight of the HGS is not one if it’s strong points as the complete stainless system weighs only 11 ounces less than the stock system so if you’re looking to lose more than a pound on your KTM 250 SX-F, you might want to look elsewhere. However, most consumers that purchase a stainless system expect to have some weight along with it and pick up durability instead right? In this case that is what I was looking for because this system was going to stay on my son’s practice bike for a while and get beat up.

IMG_1671.jpg

Like I mentioned above ,out on the track the HGS system has more bottom end pulling power and really pulls much harder than the stock exhaust through the mid range. Accelerating out of corners in second gear provides more recovery/pick up than the stock muffler and allows the rider to shift to third gear sooner than the stock system. I like that the HGS system gives the KTM a little more low end RPM response and makes the KTM feel even more playful in low speed/RPM situations. When the track is tilled deep the KTM 250 SX-F gets on top of the soft stuff better with the HGS system and each gear can be stretched out just as long as the stock system. You will not be getting any more top end/over-rev with the HGS, but for what my needs were for this bike, that didn’t matter. The overall look of the muffler isn't that appealing but I am the type of guy that is looking for function over fashion when it comes to my parts on my bike so I give this muffler a pass because it worked so damn good on the track.  

The exhaust note is pleasant and not too loud and has a similar stock sound to it. My B level son even mentioned how he liked how good the KTM 250 SX-F now felt coming out of corners and to my naked eye that was visible as well, as I was watching him. Now comes the tricky part… How do you get one? You will have to go to Bud Racing website www.Budracing-usa.com or call them at 951-245-2660. The cost of the HGS system with the Conical silencer is $849.99 and from what I have seen, they have them in stock! That’s right! IN STOCK! Something you may have not heard of since this pandemic hit.

Any questions about this system please email me at kris@keeferinctesting.com