The Ride Engineering One Piece Oversize Bar Mount has a one-piece top that is designed to resist bending much better than the stock bar mount. Precision machined from aircraft quality aluminum, there is also a 6mm difference between the forward and back mounting positions. Ride Engineering also machines their own stainless steel posts that prevent over tightening, unlike some other competing brands that DO NOT use quality posts.
We stuck the Ride Engineering one piece bar mount on our 2019 Honda CRF450R and ran it with the stock triple clamps and Ride Engineering’s Works Edition Red Triple Clamps as well. I hate realigning bent, twisted and misaligned front ends, especially during a race. I rarely bend handlebars, but I do have some screwed up twisting going on after some wash outs/tip-overs. Usually, the standard rubber-mounted bar mounts get tweaked and I've even bent the bar-mount stem a time or two while the handlebar somehow stays straight. One of the best products I've found to keep me pointing in the right direction is the Ride Engineering One Piece Bar Mount, in which I tested on our 2019 CRF450R. This $104.95 all aluminum bar mount is sturdy enough to take some crashes, but doesn't cause any added rigidity problems. I would know because I am super sensitive to any added rigidity in my front end. The flex I got on the track (from the Ride mount) is as good as the stock flex and Ride Engineering’s rubber cones are also as flexible as stock. Ride does offer a variation of different elastomers/rubber cone compounds for a custom desired flex, just in case you need a stiffer or softer feel. The Ride Engineering Fourth Generation One Piece Mount has been refined over the years to weigh as little as possible, yet stay strong. The final product is a little heavier than stock, but for the added strength that I am getting, it’s worth its “weight” in gold.
Installation is simple as the Ride Engineering One Piece Mount easily goes on with the stock Honda rubber cones or you can choose to get Ride’s rubbers (like I mentioned above) as well. The top mount is a one piece design held on with eight 8mm head bolts and when placed over a Pro Taper EVO bar, the machined guidance holes (in the mount) lined up perfectly, making it easy for me to set my bar at the right angle. Once tightened up, I forgot about this mount and didn't stress on the average tip over or any normal sized spill I may take. So, if you're like me and your bike hits the ground on occasion, this mount is money well spent. Head over to ride-engineering.com to check them out or get yours. If you do decide you need this piece, use the code Keefer-20 to see some dough.